Concentration of 1,3-dimethyl-2-imidazolidinone in aqueous solutions by sweeping gas membrane distillation: from bench to industrial scale
Ver/ Abrir
Registro completo
Mostrar el registro completo DCAutoría
Abejón Elías, Ricardo
Fecha
2019-11-26Derechos
© 2019 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license.
Publicado en
Membranes, 2019, 9(12), 158
Editorial
MDPI
Palabras clave
Sweeping gas membrane distillation
1,3-dimethyl-2-imidazolidinone
Solvent dehydration
Hollow-fiber membrane
Multi-objective optimization
Resumen/Abstract
Sweeping gas membrane distillation (SGMD) is a useful option for dehydration of aqueous solvent solutions. This study investigated the technical viability and competitiveness of the use of SGMD to concentrate aqueous solutions of 1,3-dimethyl-2-imidazolidinone (DMI), a dipolar aprotic solvent. The concentration from 30% to 50% of aqueous DMI solutions was attained in a bench installation with Liqui-Cel SuperPhobic® hollow-fiber membranes. The selected membranes resulted in low vapor flux (below 0.15 kg/h·m2) but were also effective for minimization of DMI losses through the membranes, since these losses were maintained below 1% of the evaporated water flux. This fact implied that more than 99.2% of the DMI fed to the system was recovered in the produced concentrated solution. The influence of temperature and flowrate of the feed and sweep gas streams was analyzed to develop simple empirical models that represented the vapor permeation and DMI losses through the hollow-fiber membranes. The proposed models were successfully applied to the scaling-up of the process with a preliminary multi-objective optimization of the process based on the simultaneous minimization of the total membrane area, the heat requirement and the air consumption. Maximal feed temperature and air flowrate (and the corresponding high operation costs) were optimal conditions, but the excessive membrane area required implied an uncompetitive alternative for direct industrial application.
Colecciones a las que pertenece
- D23 Artículos [522]
- D23 Proyectos de Investigación [503]